Recent content by kipliq

So basically I didn't order the first motherboard on my list it was the ASUS Z97-A ATX DDR3 2600 LGA 1150 Motherboards Z97-A now the price is $150. Should I wait till the price drops again? or I found this Gigabyte GA-Z97X-GAMING 5 LGA 1150 Z97 115dB SNR HD Audio with Built-In Rear Audio...

Which is a better buy the one Asus or ASRock Fatal1ty Z97X Killer LGA 1150 Intel Z97

The GPU that I have is a ASUS GTX 760. I use after effects, photoshop and lightroom mostly. I also would like to play Dragon Age Inquisition. My old system was a phenom II x4 3.2ghz ati 4870 1gb.

I'm using a seasonic x660

I'm slowly getting all the parts together. What do you all think of below ? Corsair Vengeance Pro Series 16GB DDR3 1866 Tested Latency: 9-10-9-27 and ASUS Z97-A ATX DDR3 2600 LGA 1150 Motherboards Z97-A Processor i7 4790k on the way

Awesome, I'm gonna build it up once Christmas is over. Do you think my gtx 760 will play the new dragon age on the highest settings?

Is the single wire sleeve beneficial or just aesthetics? I'm deciding to spend the extra $200 or save it since I have no case window.

My current is clocked at 3.4 ghz. I have 1 western digital black and a blue drive. No SSD as I will do that next year.

I know wrong page but this would be a huge upgrade for me going from the current cpu and memory to the new? I usually on After Effects/ Photoshop and I wanted to play Dragon Age 3 when it comes out. Lets say I take an hour to render will it cut the hour in half?

I just upgraded to a Seasonic X660 and a Geforce GTX 760. NOW I'm like wanting to upgrade to a i7490K and DDR3 2400. My current is a Phenom II x4 ddr2 for get the speed. Would my x660 be able to run the upgrade to i7?

Hey all I'm back after a few years rebuilding my computer I have a stock PC-A05, The single braded cables look very nice but I don't have windows or lights any benefits? Trying to talk my self out of spending $200 on a set lol. I have my wires tucked pretty good atm.

@Spare-Flair I cut out my HD rack, I have a picture in the post somewhere lol. I cut a square in the bottom leaving a tiny lip for stability.

has anyone used that type of tin snips to cut computer cases, you may mess up your case. I used a dremel, very easy to do.

I have the same setup with the BS-06 installed blowing into the case. It helped some, what helped big time is when I placed the radgrill 2x 120mm fans on the top of my case. My temps droped from 40's to 20-30's.

@one swell foop are you talking about the holes on the tray to access the screws for the cpu mounts? I seen a few people that cut out the area and it give you room if you needed to remount your cpu. Look for it, i don't remember what page. I beleive it is the a05nb not bn?