Recent content by Jeffman

Yeah I read that too, but was hoping since the Surface Laptop 4 was *just* released, I figured they haven't updated it yet either way. I haven't been in the office for a while, so I don't have the dock in front of my to look. I thought it had the Surface port on it, but could be wrong. I'll end...

Have a Surface Laptop 2 for work, and am able to upgrade to the new Laptop 4. Just need to know if my current dock will work with it or if I need to upgrade that as well. Really don't want to if I don't have to.

That's perfect. I'll shoot you a PM.

Any price in mind for the 920?

I'm honestly not sure on that. I'll try and find out.

It would be fine, quite a bit higher than I had planned for. The 920 is like $10-$15 on eBay.

Can buy off eBay, just wanted to try my hand here first. Shipping to 55024.

Bump

Any idea what you'd want for the lot? I don't think I'd need all the RAM, but if the price is right I could take it all. Realistically they only need 8GB each, possibly 16GB each if he wanted to not worry about upgrading it later.

Minneapolis area. About 45 min South.

I have a friend that's looking to do 2 budget gaming PC's. One for his 7 year old daughter and the other for his 12 year old daughter. I have a few older graphics cards I'll toss in for him, they already have monitors, and they want to pick out fancy new cases with RGB. He will buy new power...

Thanks, I think I can make sense of that info. I really need to learn more about networking. No, I don't want interruptions at all. Even very minor interruptions we have seen in the past when power goes out and we switch from primary to secondary firewalls have caused our software to lose...

No, we just remodeled and the computers are a little closer than before, but not much. I think I could get away with about 18 feet, but don't think 15 would do it. I'd have to try it I guess. It would be a tight run.

Hey, I'm looking at going to a dual NIC setup at work. This would be 100% for redundancy, nothing else. One NIC would go to one switch, and the other NIC going to a backup switch in case of failure or power outage Do I need to get a dual interface card, or can I just get another random NIC and...

Early next year I'll need to install 19 monitors that will be run at 4k 60hz. The current cables for them are 25'. I have a little slack, but don't think I can get down to 15', so I'll need to stick with 25'. I understand that 4k/60hz is hard to keep past 15'. I need it to be DisplayPort, as...