Recent content by gica

I did 3.8Mhz with Cpucore 1.193V Temps 64degreez load in Prime.HT LLC off.I I go lower the screen freezes.

And I do know about flat surfaces,lapping always improves temps by at least 2-3 +degrees.The shinny surface still looks pretty good on the sink.it is flat but not microscopic flat.Since I don't encode to use the 8 processors I think the LLC can take some time off,if I decide to use it I lower...

I remembered reading on the LLC and alot of people recommend turning it off due to the spikes in voltage that supposetly shorten the life of the CPU especially on setups that run at 3.5V or higher,apprently you cannot see the spikes unless you use an oscilloscope.Anyways the temps really...

I actually went to Fry's and bought an H50 and some Nano Diamond Thermal Paste(same ingredients as IC7) and with the same set up I still get 48-49 idle and 73-76 Prime95 load.So in my case the Noctua NH-U12P SE2 is identical.I am so curious to why I cannot lower idle at all.Maybe lapping the my...

What method did you use for the Thermal paste and which did you use?I used AS5 and a little bigger than pea size.My case is opened on the side.When I raised the CpuCore to 1.30 my temps were sky high at 85+.I was told to keep lowering thr vcore till I reached instability,well I haven't yet but...

Hi guys,happy to join this great forum,hope to get some answers. Her's my setup CPU: I7 930 Batch 3015A293 Motherboard: P6X58D-Premium RAM: Patriot PVT36G1600ELK Power Supply: Antec Quatro 850 Graphics Card: AsusEAH5850DirectCu2DIS/1g Hard Drives: 7200RPM Seagate 500gb...