Recent content by Ghys

if I may... bump

Because i cant run a cable between two train cars. I tried to just make a bridge but it was even worse.I also don't have the repeater option because both routers have atheros chip

The local network always works. I can use several devices to send pings each way and it doesn't miss a beat. When the internet connection drops, I can see it in the status of the Dir-412. It says it is disconnected to the internet and I can see it has no ip address, dns and whatnot thanks

Hi everyone I have a weird problem with my network and I have no idea what might be causing it. Long story short, I work on a train and I need to relay the signal from a Dir-412 with a Bell USB 3G stick to the next car. To do this, I use the Dir-412, a 100ft cable to reach the first Dir-615...

It was finally shipped at 4 am this morning. According to UPS, it should be here by thursday. good

still waiting for some news on mine .... *sigh*

I pre-ordered on the 4th of july and I was just told by Google that it would ship in 1-2 weeks. Needless to say I'm pissed

Hi My recently acquired Roccat Kone+ has the classic symptoms of the scrolling wheel glitch, which can be seen HERE. I have found two solutions so far: 1) blow air in it [didn't work] 2) put some WD40 in it [don't really feel like trying...] The thing is, a lot of people on the net...

I've had two heavies and they are great comfort wise. They don't stay black very long however and most laser mice hate them. I have found that laser mice die prematurely when used on cloth pads. Maybe it was just bad luck though I wouldn't use anything else, really. The comfort and the silence...

Dell XPS M1210 still going strong 4 months after bake

good idea thanks

Hi I used to have grey this bar: But now I am stuck with this ugly ass POS It's ugly, huge, slow and unpractical. Why Google, WHY ?! Has anyone found a way to go back to the old UI ? thanks

I used to have a G110. I had it for about a year and a half and I hated it the whole time. It's just so squishy to type on (granted, I'm now on a mechanical keyboard so everything else feels squishy) and the two columns of macro keys make it hard to find the ESC key on a whim or even to center...

^exactly I've repaired a few mice by soldering microswitches. The last I fixed was an MX510 by using microswitches from a Razer Diamondback and it works like a charm. It's also quite easy to solder. The only tricky part is to desolder the switch from another mouse because you need desoldering...

just position the motherboard exactly like I did (see the pictures in the previous page) and you should be fine.