LOL! Well, thankfully, I have a "guest" computer, too (four in the room, total), and I'm going to use its ram for now and see if Crucial will replace the problem ram. Worse case, I have to buy 4GB of ram. That's a whole lot better than where I was two days ago!
Great site here, and great...
Thanks, everyone who responded. His computer seems good to go, although I'll now do lots of tests. I need to do something about the ram - I'm not about to leave it in my other son's computer now.
But that can wait. I'll let this son test his computer extensively tomorrow.
Thanks again...
I ran the Windows 7 memory diagnostic on both sets of ram, and no problems showed up. However, the same ram, used in two machines, causes Prime95 to fail, so I have to assume it's the ram.
Right now, the machine is tied up with a repair installation of Windows 7 (crossing fingers!), but I'm...
I decided to swap the ram between his computer and my other son's (we have four computers in our game room), and lo and behold, no problems. I ran Prime95 on the other son's computer (which now has the ram in question), and sure enough, it fails immediately.
If I can get by with simply...
Oops, I mistyped above. I have the E6300, not E6500, but even there, the voltage is supposed to be 1.325, I think?
I'm running Prime95 with small-fft, and no problems. But if I run it blend, it fails immediately on one of the workers. I'll manually bump the vcore and see if that helps...
Magoo, thanks! My BIOS settings are now finally correct! I had removed the CMOS battery before, but didn't think to unplug the psu or to keep the battery out so long.
Unfortunately, Prime95 fails immediately. I didn't overclock anything.
HPET is set to 32-bit mode, but the mobo manual...
Well, I spoke too soon. I just booted into Windows and clicked on Computer Properties, and was greeted by a blue screen. The main thing I noticed on the blue screen had to do with "MEMORY_MANAGEMENT." I notice that "Performance Enhance" is set to "Turbo" so I lowered that to "Standard."...
Ok, I've done that now.
Funny thing is, even if the bios shows the 700 MHz, CPUZ still shows it as 1.87GHz once I'm in windows. On the other hand, if I try to set the FSB to 400, as before, the BIOS boot shows the memory running at 534, and CPUZ shows the cpu as 1.87. So, apparently...
I have two systems based on the GA-P35-DS3L. Mine has a quad core, and my son's has the E6500 cpu. We have Windows 7 x64 Professional on both.
My son's computer is now acting up badly, and I'm concerned about the hardware. The main two symptoms are on the CMOS Setup screen.
(1) if I leave...