Recent content by Decibel

Works fine...

I've never noticed any lag, even using cheap passive 2.0 cables. You will however run into signal integrity issues at anything over a few meters if you don't get active cables.

Don't be, I'm still gaming on pascal. There are five more servers just like that in the cluster I'm building, so 20 3090s. And I've been stuck in the EVGA queues since December...

They could at least have sleeved the cables and given me some RGB... There isn't even a window on the case. Jeez.

EVGA has never used styrofoam to my knowledge. It's a black open cell foam similar to what Dell is shipping servers in these days. it's similar, clear plastic molded to keep the graphics card from moving around. * Checked the closet... Black foam on my GTX 280 and GTX 1660 ti, clamshells on...

Wait, EVGA isn't doing molded foam or plastic clamshells this gen? I know they're getting pinched by Nvidia and the tariffs, but come on.

The Cross-Buy apps list is here: https://www.oculus.com/experiences/quest/section/2335732183153590/ Not all games are Cross-Buy unfortunately. So to play them on Quest you'll need to stream them from your PC with a Link cable or wirelessly with ALVR or Virtual Desktop. (Make sure to get the...

The fuckery with these most recent GPU launches has killed any need I have to upgrade my GPU. My older cards still work. I have zero FOMO, especially for consumer electronics. Also... What the fuck is wrong with pineapple on pizza? The acid brightens and opens up the flavors in the pepperoni...

My old gpu didn't stop working, why should I pay more than I need to for it's replacement? Not one damn penny over MSRP will be spent. I'll save that money for the waterblock and some shiny new fittings.

55 inch OLED in January it is then... I've been hunting an excuse.

To minimize the chance of this happening again, keep the end of the radiator without barbs as the highest point in the loop.

Let me save 17 minutes of your life:

Yup, DGX-1. Now, any ideas what to do with an old k20? Step one, zip tie a fan to it... Step two?