Recent content by dam_j

Nobody asked...

No problems with mine...

Closest as possible

See...

Same answer like last time; "Definetly NOT"

1) Did you insert the riser from the GPU side as it is shown in the manual? = Yes, at least 10 times now... 2) Have you perhaps mounted the screws forcefully through the holes in the risers PCB? (you shouldn't) = Definetly NOT and since (as i see it) the riser than were to low the GPU wouldn´t...

I think so, becourse as i see it the GPU wouldn´t fit / work otherwise. You can see the lightly glossy electrical tape on the photos.

OK, mine´s her too. I love it, BUT i just had a bit of an issue that disturbed my high quality experience a bit... The PCIe riser cable makes a short circuit with the case, hindering my pc to boot at all ! I just crosschecked it with an other pc. The only help ist to use a lot of electrical...

Why not just a second Indigogo campaign ?

I´m 43 and didn´t receive an email :-(

Delid your 7700 !

I can give you that for the NH-L9i if wanted.

?? Speculate, get a chill ?? I was just asking questions... And i even said that i will test if i could ! I think you have to chill and read what others write more carefully...

Two ideas that came to playing with my new ITX-Hardware; - Does the case have place near the MoBo for an additional 40mm (Noctua) Fan for "slightly" better airflow ? - Do you think it makes (thermal) sense to connect the metal backplate from the GPU (in case you have one) to the case via...

You think no GPU-Boost becorse of high temperatures is "fine" ???