Recent content by agheno

  1. A

    OpenSolaris derived ZFS NAS/ SAN (OmniOS, OpenIndiana, Solaris and napp-it)

    Although tech-inclined in general, I am not too familiar with Solaris so I thought I'd ask for advice on how to get napp-it running again before poking around further and possibly making it worse. After running relatively well for a few years, ESXi got corrupted and I had to do a...
  2. A

    GFI vs Nessus

    I don't have experience with GFI so I can't really give a comparison, but do double check your PCI requirements to make sure you are taking care of the 3rd party requirements. Not everything is allowed to be done in-house.
  3. A

    OpenSolaris derived ZFS NAS/ SAN (OmniOS, OpenIndiana, Solaris and napp-it)

    My ESXI 5 + openindiana (full install) + nappit is taking up 13gb of my 60gb SSD. I would think you have more than enough with 80gb.
  4. A

    OpenSolaris derived ZFS NAS/ SAN (OmniOS, OpenIndiana, Solaris and napp-it)

    I cross-flashed to LSI's P11 firmware but still had the same segment fault issue with the OI installer. Good to know. I'll let it run longer to fully test when I have more time. Your suggestion worked. I removed the AOC-USAS2-L8i, ran the OI-151a installer, powered down, added the...
  5. A

    20GB Ram Disk - I7-3930K Quad Channel

    The chrome browser on my primary desktop juggles around 300-500 open tabs at any given time. I actually switched over to chrome because firefox used to choke once you hit 200-300 tabs. I'm also not really a fan of exiting applications that I use on a routine basis -- I like them to be an...
  6. A

    OpenSolaris derived ZFS NAS/ SAN (OmniOS, OpenIndiana, Solaris and napp-it)

    I just finished 24 hours of memtest without any errors so that rules out the ram. I flashed it with the latest release that Supermicro support had, IT-FW P10. I know the card is LSI based, but is it OK to grab P11 from LSI and use that instead of the latest Supermicro firmware? I wasn't...
  7. A

    OpenSolaris derived ZFS NAS/ SAN (OmniOS, OpenIndiana, Solaris and napp-it)

    I'm following the all-in-one guide (http://www.napp-it.org/doc/downloads/all-in-one.pdf) and ran into a problem on step 7.9, installation of OpenIndiana 151a. My server has the following parts: Supermicro X9SCM-F-O Xeon e3-1230 16 gb ECC unbuffered RAM Supermicro AOC-USAS2-L8i (SAS2008 based...
  8. A

    Flashing AOC-USAS2-L8i to IT mode

    delete
  9. A

    [NEWS] Chenboro SAS2 6G Expander Board

    I checked my records and I actually ordered on July 24th. The order status has been "Awaiting confirmation by regional warehouse" since July 26th.
  10. A

    [NEWS] Chenboro SAS2 6G Expander Board

    Yeah, Provantage.
  11. A

    [NEWS] Chenboro SAS2 6G Expander Board

    I ordered on July 26 and am still waiting.
  12. A

    Blank (no holes) I/O shield

    http://www.rackmount.com/Rackmt/ATXIOShields.htm offers custom I/O shields. They mention that it is for a specific chassis type, but perhaps with a call you can have them fabricate a generic ATX chassis I/O shield.
  13. A

    AOC-USAS2-L8I Compatibility

    I'm running Solaris (Open-Indiana Live-DVD for now), and it loads the driver and detects the attached drives just fine. I'm just worried about not being able to access the card's configuration in case I need to further down the line. There is apparently a CLI utility, SAS2IRCU, that will allow...
  14. A

    AOC-USAS2-L8I Compatibility

    I just installed my AOC-USAS2-L8I card and am having some trouble getting into the configuration menu. As I understand, this is a somewhat common problem among non-supermicro motherboards and I'm attempting to use it in an ASRock z68 Extreme4. When prompted, I press CTRL-C to trigger...
Top