Computer entering boot loop

A

ArcturusX

n00b
Joined
Aug 7, 2016
Messages
4
Hey guys,

My system had a stick of RAM replaced after the previous one wasn't working. I decided to get a new stick, but my computer started to enter a boot loop once I installed it, and a GPU. I even tried the old stick of RAM and it did not work either. Still a boot loop. Motherboard screws seem to be fine.

here is my system build:

i5-6400
Gigabyte GA H110M motherboard
Kingston Fury DDR4-2400 8 gb of RAM
WD Caviar Blue 1 terabyte hard drive
Gigabyte G1 gtx 960 4gb card.

If anything else is important, please tell me to list another part. I believe that there are two beeps from the motherboard but it may be the vibration from the HDD.

Thanks in advance for your help!
 
So the addition of the guy is new as well?
What was doing video duties prior to?
How far does it go before reboot?
 
Did you try removing the GPU and trying the iGPU again to see if it persists?
 
ArcturusX said:
It goes around maybe 20-30 seconds? It used the iGPU before, the gpu is new.
Click to expand...
Boots into windows for 20 seconds or just bios/windows loading?

I concur on the trying without the gpu. If it turns out that it's the gpu it could be a few things.
Try booting into safe mode and run CCleaner to remove old drivers and install the new.
If that doesn't help, make sure you have the external power cable is connected.
Lots more things to try but try booting without the new gpu first before we go much further.
 
Last edited:
SticKx911 said:
Boots into windows for 20 seconds or just bios/windows loading?

I concur on the trying without the gpu. If it turns out that it's the gpu it could be a few things.
Try booting into safe mode and run CCleaner to remove old drivers and install the new.
If that doesn't help, make sure you have the external power cable is connected.
Lots more things to try but try booting without the new gpu first before we go much further.
Click to expand...
Problem is still the same without the GPU. The monitor just says "No Signal" It just turns off, then on again, with no signal to the monitor.
 
Check seating of ram and try and find a way to get post codes (speaker or lcds on your board maybe). Sounds like it can't find an essential piece of hardware like cpu or ram.
 
You must log in or register to reply here.
Back
Top