Ncase M1 780 ti classified

Chrytek

n00b
Joined
Jun 20, 2014
Messages
10
I know the official response is that this card doesn't fit. I have also seen other responses saying it does with a 90 degree 8 pin adapter. Is there anyone on these forums who has fit this card inside their M1?

I saw a 780 ti classified on eBay for 550 buy it now and immediately bought it. I am afraid I won't be able to use it in my M1 build.
 
Search "classified" in Ncase M1 thread:
http://hardforum.com/showthread.php?p=1040863148#post1040863148

It's just too wide.

Reference design:
o80Rnch.jpg


See the clip at the back of the case to the left, look at the cables. It's just not possible.
 
Last edited:
Correct, but when using 90 degree connectors another member on these forums said that it fits.
 
PCIe connectors have the pin running the full 20mm of the connector. Most of the "90 degree connectors" you see on ebay and so, are ones people have hacked up by hand and bent the pins. I wouldn't risk using those. However, there are some Dell Alienware computers with a custom 90 degree 6-pin connector. But it's still 20mm tall, and how are you going to deal with the extra ground wires needed for the 8-pin?

A better idea is removing the socket housing from the board, de-soldering the pins and re-soldering a socket that has a different orientation. Molex makes all kinds of 6-pin and 8-pin sockets for the MiniFitJr connector series.
 
PCIe connectors have the pin running the full 20mm of the connector. Most of the "90 degree connectors" you see on ebay and so, are ones people have hacked up by hand and bent the pins. I wouldn't risk using those. However, there are some Dell Alienware computers with a custom 90 degree 6-pin connector. But it's still 20mm tall, and how are you going to deal with the extra ground wires needed for the 8-pin?

A better idea is removing the socket housing from the board, de-soldering the pins and re-soldering a socket that has a different orientation. Molex makes all kinds of 6-pin and 8-pin sockets for the MiniFitJr connector series.

Thanks WiSK, that does seem like the best shot at making this work. I'm a little nervous about voiding my warranty so I plan on running the card a a month or two before attempting this.

However the reason I wanted the classified was because I wanted to overclock the gpu for the performance increase. My reasoning is this, the monitor I have is 3440x1440. I believe the overclocked 780 ti is enough to run on this monitor beautifully, with the stock not really being enough power. I wasn't able to find an answer when doing research. If the superclocked version is strong enough I would probably just sell this card and buy that one.
 
I thought the difference with the Classy variations is that they have better/more VRMs, so they are aimed at the overclocker market. It's still the same chip under the hood as the stock 780ti.

Are you going to overclock it? What games are you playing?
 
I see nothing in dPunish3r's build logs that refers to an EVGA Classy. His original build (that you linked) had a 780Ti, and the update used a Titan Black, both running reference coolers and PCBs.

The only reference to a Classy that I see in the whole of that sheet is user 'dev's intent to put "GTX 780 Ti Dual Classified EVGA Hydro Copper", but listed purely as "planned". I'm going to bet that plan didn't quite carry through, for a number of reasons.
 
Back
Top