No POST, endless reboots, ASUS P5E

  • Thread starter Deleted member 89137
  • Start date
D

Deleted member 89137

Guest
Specs are in my signature. I pulled the cpu to redo the thermal paste. Reinstalled it, and now it won't post. It just reboots over and over and over.

I bought this horrible heatsink (arctic freezer 7 pro revision 2) and I think it's not making proper contact, as it's near impossible to tell if the screws are all the way in.

Any insight?
 
Possibility of socket pins not making good contact or perhaps board warping due to uneven pressure from the cooler mounting. I would check for those two first.

-Raja
 
I've reseated the cpu 3 times now, running only the cpu and RAM and its still doing it. I reseated the memory. The fans just spin up and stop, spin up and stop, over and over.
 
Pulled the cpu once more, looks like one of the pins in the socket is bent, and also one appears to be missing. I am beyond confused...
 
Bent is fixable, missing is pretty bad :(

When you say "pins in the socket," do you mean the pins on the cpu, or the even smaller contacts inside the holes in the socket that touch the cpu pins?
 
It's an epidemic. I've got two Gigabyte boards doing the same damn thing.
 
Maybe the cpu is not supported by the mootherboard, please do check the website link cpu support list.
 
@pchealth 2: The P5E supports all LGA775 quads, and besides, he already had the chip running in his system. Read the first post again.
 
You said a pin is MISSING?
Did you check around the computer case, socket area and work area for that pin?
I'm sure it wasn't that way when you first built the system, right?

It could be very likely that you damaged the socket when removing the CPU from it. That's actually a lot easier to do than you think. My guess is it was either removing it in an uneven way, or the heatsink being stuck to the CPU when trying to remove the HS. Just wild guesses...

Some people manage to insert it improperly, too, with both keyed sides not fully inserted, and then latching it down, although that will do a lot more damage....
 
It could be very likely that you damaged the socket when removing the CPU from it. That's actually a lot easier to do than you think. My guess is it was either removing it in an uneven way, or the heatsink being stuck to the CPU when trying to remove the HS. Just wild guesses...
..

Well yeah, I think it's pretty clear that the socket wasn't mysteriously damaged by ghosts....:rolleyes:
 
Once you destroy a single pin on an Intel socket, the whole motherboard is toast. On the plus side, everything else is likely still good.
 
Back
Top