Italiano86
Limp Gawd
- Joined
- May 26, 2008
- Messages
- 252
I wanted to lower my voltage on my 2500k which is set to 4500mhz so I am using a negative offset which is currently set at .070 which seem high, but it works. Thing is, the bios shows this setting as red, which begins at .065. Is there a danger of undervolting if this setting is red? I am thinking this is only if using a positive offset value .065 and above.
The chip idles at .944 and loads at 1.296v. I have pll overvoltage enabled and the phase settings at their second highest. Other than setting the voltage at manual, using this high offset seems like the only way to keep the voltage down.
The chip idles at .944 and loads at 1.296v. I have pll overvoltage enabled and the phase settings at their second highest. Other than setting the voltage at manual, using this high offset seems like the only way to keep the voltage down.