Trying to fix an old computer...

Eihli

Gawd
Joined
Nov 20, 2003
Messages
610
Someone dropped off a non-working Dell XPS 400 (old piece of crap) that I was going to fix and give away. It was missing a PSU, and I was told that was the broken part so I threw another PSU in there and go to boot it up...

It turns on for about 10 seconds, then straight off and loses power. I push the power button again and all the fans come on at very high rpms (pretty violent compared to the prior boot) and then it loses power again, except this time it never even tries to boot. On and off real quick.

I replaced the PSU and the same thing happened. Tried different RAM, same.

Thinking it may be the motherboard or CPU... I do have a C2D and C2D compatible motherboard I can put in there but I want to be sure, as I'm not sure it'll fit or if Dell motherboards can even be removed.
 
Upon disassembling the computer for spare parts and to throw the rest away in the trash, when I removed the heatsink the CPU fell out... and I realized that I didn't have the gate closed. Well the gate was closed but it wasn't on top of the tab, so the heatsink wasn't touching the CPU.

Would this cause the computer to cycle off within 10-15 seconds?
 
Seen that same symptom on a friend's XPS 400 too. Turned out to be the motherboard was bad, probably baked to an early death by that awful Prescott based Pentium D it had in it. I picked up a replacement BTX style board cheap off ebay with a G965 chipset and put a Core 2 Duo CPU in it instead. It's still working fine with all it's original parts.
 
Did you try and replacing the CPU in the socket and installing the heat sink and try booting the computer back up. If the CPU wasn't being touched by the heat sink the CPU was overheating, and the computer was turning off instead of burning the CPU up. The next time you booted it up the fans said "OH SNAP!" "the CPU is REALLY hot, turn the fans all the way up" that is if the motherboard has thermal control on it, which it sounds like it does.

so install the CPU, thermal paste it up and locked that heat sink back in for another boot up... that is if you didn't already trash the whole get up.

Best luck
 
I think Dell uses a proprietary power supply. If memory serves me correctly, the main connector has the pins clocked a bit differently.
 
Usually the high fan speeds mean the motherboard is fried... but yeah, since the latch wasn't on properly, try it and see what happens.

I have also seen a few cases where the heatpipes in the Dell heatsinks have gone bad and aren't transferring heat anymore. The fans will run at full speed when that happens and the heatsink base will get extremely hot.
 
I think Dell uses a proprietary power supply. If memory serves me correctly, the main connector has the pins clocked a bit differently.

On the XPS 400 you can use a standard ATX PSU. Dell hasn't done the proprietary PSU in thier consumer products for some time thank goodness. The XPS 400 motherboards do not have any common failures I'm aware of.

I would say properly seat the CPU ( pray it didn't get fried from improper installation ) but before you do check the CPU socket for bent pins. If all seems well in the socket, apply some thermal paste, attach the heatsink and try to fire her up with no ram or drives attached and listen for the memory beep code. Pull all pci/Pci-E x16 cards as well. If it beeps at you in an angry manner, install some memory and a video card only then try to make it into the bios. If you can get into the bios add your optical drive and HD and fire up a UBCD and start testing the memory and hard drive. If that works then you're good to go, just rinse, lather and load OS.
 
Back
Top