Soldering a capacitor

Cerulean

[H]F Junkie
2FA
Joined
Jul 27, 2006
Messages
9,484
Ok, so on my two 19" LCD monitors I found busted/bursted/blown/round caps on the power supply board. I took them off, made some marks, and ordered new ones. So now I have the new ones.

Is there a positive and negative end? A wrong way to install a capacitor? Do I just simply put the capacitor through the two holes on the board where it is supposed to go, regardless if which wire goes through either hole?

The type of capacitor I am talking about are one of those small, tall cylinder capacitors.
 
All the soldering is done on the same side, the bottom. So just make sure you put the capacitor up above with the rest of the components. Don't want to solder the capacitor, by accident. :( Capacitors are all on the same side.

Not sure if I explained it very well...

Anyways, good luck :)

http://www.technomotive.com/howto/ecu1g/capsolderin.jpg

The url above explains it well.

Is there any + or - on the capacitor?
 
Last edited:
Yes there is a pos and neg. Putting them in the wrong way can result in "POP" goes the capacitor.

One of the services we offer at the shop I work at is recapping hardware so I have a bit of experience with this :) Recapping is also a good way to bring Shuttles back to life as they have serious cap failure issues ;)

The stripe on the one side of the capacitor goes facing the white hald of the capacitor socket which tbh you should have paid attention to when you took the old ones off and you wouldn't have to ask this question.

radial-capacitor-polarity.jpg
 
Last edited:
Also be careful on how hot you are setting the soldering gun. Too much heat, and you'll burn through into the surrounding traces.
 
What if it is shaded in black? Only black ink was used...

EDIT :: Nevermind. I looked at some other capacitors that were on the board, now I see! :O

I think I just screwed up one monitor's psu.
 
The stripe on the one side of the capacitor goes facing the white hald of the capacitor socket which tbh you should have paid attention to when you took the old ones off and you wouldn't have to ask this question.

radial-capacitor-polarity.jpg

except for backwards asus boards where silkscreen marking = positive :p

OP: how did you screw up? Just remove & rotate if it's in backwards.
 
Yeah, I'm in the process of desoldering. :\ Had to buy a tip, a new iron (mine popped), a desolder vacuum tube, and a coldheat tip. I fixed one of the 19" LCDs, and now I'm using it for my 2nd monitor on my lappy. :)
 
Back
Top