Dual XEON Problems on SuperMicro Board

  • Thread starter Deleted member 16178
  • Start date
D

Deleted member 16178

Guest
I am having a problem with my SuperMicro X5DA8 Dual Xeon, Socket 604 motherboard. Motherboard ran fine with 12GB of RAM, until I upgraded the BIOS from REV 1.2 to 1.3b. Now it will not boot with all memory. Works fine with anything less than 12GB. I threw in an AGP video card (had PCI before) and set the AGP aperture to 256MB, and now it will boot with the 12 GB, but only reports 11.5 GB with all 6 DIMMS installed.

Any ideas?

x5da8_spec.jpg
 
Lower the aperture. You only need that as an overflow for the GPU and obviously you are not using this as a gaming system. 32 or better yet, 64 (default) aperture will be fine. You will also get some of the memory back.
 
Lower the aperture. You only need that as an overflow for the GPU and obviously you are not using this as a gaming system. 32 or better yet, 64 (default) aperture will be fine. You will also get some of the memory back.

Thats the problem, with a low aperture, the system will not boot. It seems like there is an problem with having too much memory. When the aperture is lowered, the system boots fine. If I take out 2 sticks (6 total) it boots fine as well...

This all happened after firmware upgrade to 1.3b...
 
What does it show under system memory and extended memory in the bios when it does boot? What do you have the enable memory gap setting as?
 
Why did you update the BIOS?
Can you flash it back?

I updated the BIOS because REV 1.2 had problems with certain PCI cards in certain slots. Also, the original BIOS was from 2002... (I know, I know, don't flash unless there is a "real" problem).

I have not been able to locate the old BIOS 1.2 anywhere... :-(

What does it show under system memory and extended memory in the bios when it does boot? What do you have the enable memory gap setting as?

System Memory shows the correct 12GB. Once the OS loads, it only shows 11.5GB. Unfortunately, there is no Memory Gap setting in BIOS.
 
System Memory shows the correct 12GB. Once the OS loads, it only shows 11.5GB. Unfortunately, there is no Memory Gap setting in BIOS.

Memory Gap should be under the Advanced tab and then under Advanced Chipset Control, it's not there?
 
Back
Top