guys, my computer and i have a problem ;'[

mateasluzes

Weaksauce
Joined
Dec 21, 2007
Messages
103
either the psu or the motherboard aren't working

when i turn my computer on, usually the mouse, keyboard, and monitor would turn on
yet now not even the mouser turns on
i've taken out the RAM, video card, HD, CD drive, etc, and it wouldn't make those beeps that it normally would when there isn't any RAM in, which leads me to believe that it's the mobo
but then i took everything out and just plugged in the dsl cable and it would turn on which would lead me to believe it might be the psu

is there anything i can do??
 
test the keyboard, monitor, and mouse on a different computer if you have one available...
I had a problem a few days aog where my computer wouldn't recognize my USB mouse.
After i cleared the CMOS, the computer recognized the mouse again....

do you get anything displayed on your monitor?
 
i'm currently using the same mouse, keyboard, and monitor on my old computer so they're working perfectly fine
but what do you mean if i get anything displayed in the mobo?
 
no, it won't even turn on, which means it wouldn't read the video card, which would mean that a) the motherboard's fried or b) the psu is faulty
 
no, it won't even turn on, which means it wouldn't read the video card, which would mean that a) the motherboard's fried or b) the psu is faulty

can you test another psu or try the video in another machine?
it sounds to me like it may be the psu....
one of my old builds, everything would power on, fans light up and spin, but never got a monitor signal... ended up being a POS power supply
 
i can't because my old computer isn't good enough to power the 3870

and if it's the psu, would that really explain the mouse and keyboard not turning on?
 
i ordered the parts the 25th, arrived the 27th.. lol
would newegg take both and replace them??
 
/*------------- <cut n paste> -------------*/
If you have both the 20/24 pin main ATX connector plugged in, AND the 4-Pin (or 8-pin) ATX12V P4 CPU connector plugged in, then the board should boot fine (unless it requires more power connectors from the PSU). You could try clearing the CMOS.

You could test the PSU. Jump start it (on the main atx connector, short the green wire with any black wire, using a paperclip), and see if it stays on. If not, then its probably a faulty PSU. If it works then you can proceed with the suggestions below. ***NOTE: The paperclip trick is a simple test for those that do not have PSU testers, multimeters, nor a spare PSU to test with. It is not a 100% conclusive test of the PSU.

Setup everything outside of the case, with the mobo on top of its cardboard box. Plug in only the essentials:
- PSU (namely: main 20/24-pin ATX connector and 4-pin ATX12V P4 CPU Connector)
- CPU w/ HSF
- Single stick of ram
- Videocard if there is no onboard video
- Monitor
- Keyboard
- System speaker/buzzer

* Use a screwdriver if your board doesnt have an onboard power switch. Jump the two power switch leads to turn the power on.

If it won't post, try different RAM slots. If it still won't post, pull out the ram (so no ram in the system) and listen for error beeps. If none, pull the vidcard and listen for error beeps. If none, re-seat the CPU and HSF, then try again. Report back with results if you're still having issues.
/*------------- </cut n paste> -------------*/
 
* Use a screwdriver if your board doesnt have an onboard power switch. Jump the two power switch leads to turn the power on.

what does that mean?
 
use something to momentarily short the 2 pins that you normally attach to your power on switch.
 
Back
Top