New Rig Built trouble booting now

vidoprof

Limp Gawd
Joined
May 3, 2007
Messages
468
I just built a new rig.

Q6600
Gigabyte DS3L
4 gigs ram (4x1)
Corsair 520 PS
Artic Pro 7
EVGA 7600 GS
Rosewill RAID PCI IDE card

I can't imagine that my PSU would not be able to power this setup.

I did an install of Vista then after a few days (running fine) I hated it and started over with XP. I had the XP install for a day and then ran all the updates for XP under Windows update. I am done installing everything and leave for work and turn off the machine.

I then come home now and try and turn it on and it starts for about 3 seconds and then turns off, then after 4 seconds powers back on and does this over and over.

Any ideas?
Thanks
Ryan
 
Have you checked to make sure the heatsink is seated fully on your CPU? It sounds a little bit like an overheat issue.

Another thing to try, unplug the power supply leads from all your drives, video card (can't remember if the 7600 GS needs a power connection), and motherboard. Take a paper clip and short the green wire to any of the black wires to force the power supply to kick on. If it stays on, remove the paper clip, connect one drive up, and repeat to see if the drive powers up. Keep doing this until you only have the video and motherboard connections left. Plug everything back in and try it again.
 
Thanks for the tip. Looks like it might be the Rosewill card. I don't know what is going on with it though.

I took out that card (I was about to start from scratch and take everything out), and now it powers on and stays on. I put it back in and wham nothing. I take it out everything is fine again.

Damn card. At least I HOPE that is what it is. So far with the card out, going on 10 mins no problems.


Ryan
 
I will do that.

I actually only needed it because I had two IDE burners that I wanted to run off that card, but one of my burners went bad (it's 2 years old Plextor). Not sure if that is still under warranty though, so I might try and send that back too.
 
When you say "went bad," what do you mean? The tray no longer opens? It won't read regular media? It won't read burned media? If its not a mechanical problem, you could try flashing the firmware. I believe plextor only has one year warranty.
 
I think your best bet is to RMA the card or simply sell it off and move up to SATA optical drives. I know I have faced the same problem, as I have a pair of Lite-ON IDE DVD burners that were fantastic, but I won't have any IDE slots on my next board. If you have the space in your SATA slots then simply getting SATA opticals might save you a lot of trouble.

I do have a question about your rig, if you don't mind me prying. Why did you buy a quad and 4 gigs of ram and then get a 7600GS? What are you using this system for?
 
Back
Top