Monitor not getting signal

salamyen

n00b
Joined
Jun 25, 2007
Messages
9
I just built a computer. E6600, 8800 GTS, 620W PSU, LIAN LI CASE, 2Gig Corsair ram, and a raptor HD. For some reason, my computer will start up, run windows perfectly fine for 5 or 6 minutes then the monitors will say "no signal" and stop responding to the computer. ANY help will be appreciated!
 
ya, I actually have 2 monitors because I was running both through the computer. They both get no signal.
 
Few questions for you.
1) Are you running the monitors using DVI or DSUB (vga)?

If you are running DVI, try a vga cable and see if it works. If it works, then the DVI port from your video card or monitor might have some issues.

Also, try using another DVI cable. I recommend the ones at monoprice, or use another cable that has no known issue (possibly a friend's) and see if that takes care of the problem.

2) WHat is is you monitor brand? It's not Sceptre, is it? Although i know most monitors are plug and play, some manufacturers use their own driviers. See if they have one for your model and use that to see if it makes a difference.

3) Your problem could also stem from refresh rates problems. Check your manufacturer's manual and set the refresh rate according to the spec.
 
It may be possible that the ports on your card aren't quite lined up exactly at the rear of the case which could mean you're not getting a great connection to the card. On my new build I had to shimmy over my video card a fraction of an inch before I tightened it down. If I didn't do that I wouldn't get a good connection and would loose my monitor signal.

You might want to check to see if you're getting the cable all the way onto to the port. Just a thought...
 
2) WHat is is you monitor brand? It's not Sceptre, is it? Although i know most monitors are plug and play, some manufacturers use their own driviers. See if they have one for your model and use that to see if it makes a difference.

ahaha, i hope its not sceptre, i have an x9g naga 4 sitting here thats dead as a doornail for no reason.
 
ahaha, i hope its not sceptre, i have an x9g naga 4 sitting here thats dead as a doornail for no reason.

Lol, i had a similar problem as the OP. I couldn't figure out why my monitor kept on dropping the signal on DVI intermitently. VGA worked fine. It turned out my Sceprtre X20 Naga had a faulty DVI port. Happened to one of my friends too. So now i cant recommend sceptre.

(Back on topic) But since the problem is happening on 2 of the OP's monitors, it could be the cable, vga card.
 
Back
Top