So I just did a clean install of Vista tonight. I have 2 Sata drives, my main one with the O/S, and then a 2nd one from my previous install that I use to access older files (not set up in a RAID or anything). I installed Vista with just the primary connected and everything went fine.
After installation was done, I connected the 2nd drive and all was still well - until I installed the Nvidia chipset drivers. Now Vista hangs up and takes forever to fully load, and then even though it shows the 2nd drive, i cant access it. If I disconnect it from the mobo everything is fine again. The 2nd drive is an 80GB Hitachi, I believe only 1.5 Gbit/s.
My board is a P6N-SLI-FI...when installing the chipset drivers I also installed the IDE SataIDE Driver in the file package (nForce 680i SLI/680i LT SLI - Windows Vista 32-Bit, version 15).
Anybody know what the problem may be and if so, how I go about fixing it?
After installation was done, I connected the 2nd drive and all was still well - until I installed the Nvidia chipset drivers. Now Vista hangs up and takes forever to fully load, and then even though it shows the 2nd drive, i cant access it. If I disconnect it from the mobo everything is fine again. The 2nd drive is an 80GB Hitachi, I believe only 1.5 Gbit/s.
My board is a P6N-SLI-FI...when installing the chipset drivers I also installed the IDE SataIDE Driver in the file package (nForce 680i SLI/680i LT SLI - Windows Vista 32-Bit, version 15).
Anybody know what the problem may be and if so, how I go about fixing it?