Win7 doesn't recognize the hdd/raid

C

csnv

Limp Gawd
2FA
Joined
Nov 11, 2009
Messages
216
connected to this controller card: SYBA SY-PCI40010 PCI SATA II Controller card.

I'm new at this, anyone know if I have to do something else after setting up a raid ?.. i installed the driver in windows but could not get it to recognize it.
 
make sure you're loading the right windows driver that's appropriate to the version of windows you're running. are you tryignt to install windows to a raid set on this controller?
 
no, the windows is already there, i just installed the card with 2 drives (it recognized my drives, I set up raid 1), reboot and get into windows, manage disks, nothing.. no raid drive.. so I installed the raid drivers, still nothing.. reboot, still nothing inside windows manage disks. (throughout all this, the raid card still works/not dead because i can see it recognize drives as i boot up ... just win7 doesn't see the raid)
 
right click on my computer, click on manage, and go to device manager. Right click at the top of the pane on the right and click on detect new hardware changes. It will go through a forced refresh. See if there are any question marks or explimation points.
 
J-Will said:
right click on my computer, click on manage, and go to device manager. Right click at the top of the pane on the right and click on detect new hardware changes. It will go through a forced refresh. See if there are any question marks or explimation points.
Click to expand...

Yeah i think that's the next step... get down and dirty with this card. I thought it would be easy since it went smoothly until i get in windows.
 
You must log in or register to reply here.
Back
Top