Water + Abit NF7-s = ?

ec_hern

Weaksauce
Joined
Jan 30, 2004
Messages
107
Ok, so I noticed that my temps were getting a little higher than usual, so i went ahead and took off the block to make sure i was getting good contact and nothing was lose, and i noticed something was lose. so to tighten it i have to remove one of the tubes, so i drain all the water out and get started. i get the mainboard out, everything pluged in, i tilt my case back up, and NOOOOOO water from the radiator i have mounted on the top of my case, spills out and drips down through the mainboard. Nothing was on though.

I pulled out a duster and emptied the entire can on the board, doesnt seem to be any wayter anywhere.

If i let it totally dry will it be ok?
if i can let it dry then power up, how long till it dries?
 
should be ok, maybe try taking a hair dryer on the low setting to it to make sure you get all the water out of all the nooks
 
Welcome to watercooling....I've had to wait a few times for parts to dry off heh. OH well , it gives me something to do.
 
If you are using distiled water like you should be. It normally won't conduct electricty anyways.
 
Originally posted by Kingofl337
If you are using distiled water like you should be. It normally won't conduct electricty anyways.

D34DC0W says: Hi Adam.

Distilled water is what you should indeed be using, and take a few days and let the beast dry out a bit first.

I'll say from experience that water on an Epox 8RDA+ does nothing :p :D
 
Back
Top