Trouble Re-Flashing Bios

WiKiD

n00b
Joined
Jun 23, 2004
Messages
27
While attmepting to reflash the BIOS on my Chaintech VNF3-250 i keep getting stuck at one point. I downloaded the bios and extracted it to a floppy. When the computer is booting i press Alt+F2 to start the reflash. It just says "Decompress "AWDFLASH.EXE" from BIOS, Please wait ..." and stays there. Anyone know what i am doing wrong here?
 
Ok, so i put the new bios and awdflash.exe on a disk and booted int eh command prompt. In the A directory i typed awdflash VN120A19.BIN it then goes to what appears to be the awdflash screen and just freezes again. I am beginning to think this mobo is just Fubar.
 
I once had an old Slot A Epox board that did something similar, it stopped in the middle of updating the BIOS and I had to reboot but now it won't even get to that screen anymore. However, I had an identical board and simply took the BIOS chip off that one and stuck it in the borked one and it worked (so I would need to buy a new BIOS chip to run them both). I don't think modern board have a BIOS chip you can just take off but you may have to send it back and have Chaintech reprogram it. Try to get ahold of their support staff.
 
ohnnyj said:
I once had an old Slot A Epox board that did something similar, it stopped in the middle of updating the BIOS and I had to reboot but now it won't even get to that screen anymore. However, I had an identical board and simply took the BIOS chip off that one and stuck it in the borked one and it worked (so I would need to buy a new BIOS chip to run them both). I don't think modern board have a BIOS chip you can just take off but you may have to send it back and have Chaintech reprogram it. Try to get ahold of their support staff.

Have you ever heard of a "hot" flash???

Requires some big brass balls. No shit.

Make a boot floopy that has a copy of a flash utility and a working copy of the BIOS for the board you are going to flash.

You boot to the floppy using the motherboard with the BIOS chip that works. Then, you *CAREFULLY* (I practiced and made sure the chip was loose in the socket) take out the good BIOS. You then insert the badly flashed BIOS in the motherboard (while it is on, I said you had to have balls) and then flash it with a good BIOS.

I have done it twice... scary, but it works.

Good luck!

-Skystalker

PS: sorry to hijack the thread.
 
Skystalker said:
Have you ever heard of a "hot" flash???

Requires some big brass balls. No shit.

Make a boot floopy that has a copy of a flash utility and a working copy of the BIOS for the board you are going to flash.

You boot to the floppy using the motherboard with the BIOS chip that works. Then, you *CAREFULLY* (I practiced and made sure the chip was loose in the socket) take out the good BIOS. You then insert the badly flashed BIOS in the motherboard (while it is on, I said you had to have balls) and then flash it with a good BIOS.

I have done it twice... scary, but it works.

Good luck!

-Skystalker

PS: sorry to hijack the thread.
Wow, I didn't think you could do that. These computers are pretty old so maybe I will give it a shot. You are serious, right?
 
Back
Top