Shorting USB Ports?

jedihobbit

Gawd
Joined
Nov 3, 2005
Messages
963
Seem to be having an issue with the front USB ports on DreamCatcher. Recently is seem that half the time when I plug my ScanDisk Titanium thumb drive into one of the front usb ports of the MicroFly some sort of reboot occurs. It ranges from the equivalent of a reset all the way to a power off. The last time this happened is seems to have “killed” my UPS. Could this be from ye old “static discharge” or is there an issue with a component(s)?

The primary components (balance in my sig) involved are :
1.Customized MicroFly mATX case
2.ScanDisk 1Gb Titanium thumb drive
3.BioStar Tf 6100-939 motherboard

This does not seem to occur only any other computer I have used the thumb drive on. So, help!
 
Sounds like your computer has a grounding problem, or a short some place.
 
Do you have a multimeter? I had a similar problem with the Antec Fusion. that case had a metal front face. I checked with my multimeter and there was no continuity between the front and the rest of the chassis. I was able to shut down the computer by touching the front.
 
Do you have a multimeter? I had a similar problem with the Antec Fusion. that case had a metal front face. I checked with my multimeter and there was no continuity between the front and the rest of the chassis. I was able to shut down the computer by touching the front.

Maybe someting there as I have been making a major effort to touch something that is grounded first before inserting thethumb drive. I haven't had an issue since the UPS went poof.
 
Sadly, I don't have a satisfactory conclusion to my story. It is a secondary computer that I don't use all that often, and I haven't had the problem with it for a while. I would recommend checking continuity between the outer shell of the USB ports and the PSU or chassis, which should be earth grounded. You can also check that by testing continuity between your PSU case and the ground pin in the electrical socket (be very careful with that one).

I wouldn't recommend doing this when the computer is on, but you should leave the PSU plugged in in order for the case to be grounded.
 
Back
Top