Problem removing a mobo from a case, need suggestions...

Paithar

[H]ard|Gawd
Joined
Jul 17, 2003
Messages
1,049
I recently built myself a new pc. I got a new case and everything. So I was going to give my old mobo to my dad because he wanted it. I still wanted the case it was in however so I proceeded to try to remove the mobo from the case. The mobo tray is not removeable.

So I take my trusty screwdriver and proceed to try to remove the screws holding the mobo in. I stress the word try because it would seem that the motherboard standoffs have somehow stripped the holes they are in on the motherboard tray. They loosen but do not come out. They also do not tighten back up. I have no idea how this happened since they were initially tightened.

So I need suggestions on how I can remove the mobo without ruining the mobo or the motherboard tray in the case. Anyone have any ideas for me?

Thanks
 
As you are unscrewing, gently lift the motherboard while still turning the screw. Hopefully the stand off can grab onto another thread in the motherboard tray and back itself out.

OR

If you can get at the back of the motherboard tray, try to screw the stand off back into the motherboard tray by applying a bit of pressure downward (not too much tho). The standoff might show thru the back of the tray in which you might be able to get ahold of it with a vise-grip or some other pliers.
 
common problem. not much you can do to fix it either, once you get the standoffs out.

well, I suppose if worst comes to worst you could just drill them out from the backside and then find some of those plastic standoffs, they should work with a slightly larger hole.
 
Thanks for the suggestions, I appreciate them. I'll have to see I can get at the back of the mobo tray. Otherwise I have a funny feeling the whole case is going to have to go over to my dad. Oh well if that's the case.
 
Back
Top