P4P800 Deluxe

T Phat

n00b
Joined
Mar 10, 2004
Messages
2
I'm looking for some insight here. I bought a new motherboard, ram, p/s, and CPU.

New:
Motherboard: p4p800d
Ram: 256x2 ddr 3200 (slot 1 and 3 dual channal)
CPU: Intel P4 2.8HT
300w P/S (Generic)

Old:
Nvidia 128Mb 4200 Ti
LG CD/RW 32x8x4
Standard issue floppy
30GB maxtor HB 2Mb 7200rpm

Problem:
Wiped/reloaded winxp
installed M/B drivers ie..
installed 53.03 nvidia drivers
installed 3com drivers
installed SP1
installed Battlefield 1942
installed Microsoft Flight Sim 2004
played games, went to bed...woke up and turned on Computer. No go, computer totally unreponsive it did not even POST. Took back computer to store wher it was bought and they told me that the M/B was fried. Ok there must be a problem with the M/B so they covered it under warrenty and installed a new one there. All the other components passed their tests.
Got the new on home, played a few games, turned it off, went to bed woke up and the computer had decieded to do the exactly the same thing. I have a sony newwork walkman(mp3 player) and my digital reciever connected to it...just the same as my previous system. The old system was exacly the same setup only with a asus CUV4X, p3 750, and 512 ram.
Anyone have any ideas to this? It would greatly help. Let me know if I can provide more information.
BTW I do not overclock and run everything pretty much stock.
Thanks!
 
Does the system give any indication of power when you hit the button or is it totally dead? Are there any beep codes?

My first thought on this involves the power supply. You need a Pentium 4 compliant power supply to be on the safe side. Are you hooking up the P4 4 pin power lead to the board? If your PSU doesn't have it then it is not compliant.

The boards may not have been fried. They just may not get enough voltage.

With out actually testing the components though that's up in the air.

But Asus is known for good quality boards and if you have been through two of the same boards I would look to your most likely suspect first. The PSU.
 
Indeed there is a 4 pin lead to the board as well as the ATX lead. The power supply is only a P4 300w but should be sufficant as the only card I have installed is the AGP vid card and it is a 1.5v that complies with the mainboard specs.
One agp, one HD, one FD, one CDRW.
My concern is that maybe the reciver I have hooked to it is causing a problem but all products that come in to Canada (where I live) is FCC complient...meaning they can take a certain amount of interfirance w/o problems.
 
Not all power supplies are created equal. A volt meter is usually required to be sure about the voltages your PSU is outputting.

I have a failed Antec 430Watt supply that will boot a machine but doesn't put out enough voltage to spin the hard drive. The 12 volt leads put out between 9 and 10 volts instead of 12.

Just because its 300 watt doesn't mean that its working properly.
 
I most definatley agree with you on that one. Generic PSUs are a crap shoot.
 
Back
Top