OCZ Reaper OC'ing help needed

[ZombieDB]

Hi All,

Recently I got some OCZ Reaper HPC 2GB sticks for my setup with the intent of OC'ing it some to get a tad more performance out of it. I've tried doing so even with (what I consider) conversative settings and it seems that anything off of SPD that I put ends in no POST or a failed MemTest. Could anyone spare a few minutes and reccomend timings for me? Thanks!

What I'm using:
OCZ Reaper 2x1GB, Asus P5B-Plus Mobo, Intel Quad Q6600 Kentsfield 2.4GHz

What my current SPD settings are using (according to MemSet)

CAS Latency: 5
RAS to CAS Read Delay: 5
RAS to CAS Write Delay: 5
Precharge Delay: 15

Refresh Cycle Time: 42
Performance Level: 7
Write to Precharge Delayed: 14
Write to Read Delayed: 13
Act to Act Delayed: 4
Read to Write Delay: 8
Read to Precharge: 5
Precharge to Precharge Delay: 2

Thanks again

 

[mart20012]

I have a OCZ reaper HPC PC-6400 2GB kit also.

My timings are 4-4-4-15 2T (as per the specs it should be at). I think yours should be at the same timings if it's the same kit.

I'm on a p5n-e sli with a e6400 overcloked to 2.8. For some reason, I can't get any higher than that. I'm also at a ration of 7:8 since the memory is running at 800 and the cpu at 2.8.

I tried to make the processor at 3.2 and memory at 800, but it wouldn't post at all.

Do I have to put the memory at a higher speed to achieve 3.2?