• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Normal Temperature?

M

MeXPuNk3r

Limp Gawd
Joined
Dec 18, 2001
Messages
378
i have a friend who believes his machine is overheating, what would you guys say are normal temperatures (air cooled) for a 2500+ ?
 
current my barton 2500+ running at stock speeds with a system temperature of 33c is around 50 to 51c full load. It runs at full load all the time cause I have F@H running.
 
grethor said:
current my barton 2500+ running at stock speeds with a system temperature of 33c is around 50 to 51c full load. It runs at full load all the time cause I have F@H running.
Click to expand...
yah so his at 67C is deffinately a prob...
 
MeXPuNk3r said:
i have a friend who believes his machine is overheating, what would you guys say are normal temperatures (air cooled) for a 2500+ ?
Click to expand...

Here's my standard form letter:

Check the following for overheating or perceived overheating:

- Is the heatsink correctly installed ?
--> Verify it is correctly installed.

- Is the heatsink filled with dust and crud ?
--> Clean with compressed air in a can.

- Is the heatsink fan operating ?
--> Replace defective fan with similar or better unit.

- Is the heatsink adequate for that application/CPU ?
--> Verify it meet the requirements for the CPU being used.
--> RETAIL heatsink? May require lapping and better TIM.

- Is thermal interface material used between heatsink and cpu ?
--> Verify it is used, and is applied according to the manufacturers guidelines.

- Is the TIM pad cover removed from heatsink before installation, if using supplied TIM pad ?
--> Remove the cover before installation, failure to do so will insulate the cpu from the heatsink.

- Is there adequate airflow or case ventialation ?
--> Verify airflow, add case fans if required.

- Is the Vcore set higher than specified by the manufacturer ?
--> Verify the Vcore is set to the manufacturers specification in the mainboards bios.

- Is the temperature read via the internal temperature diode. Is the tremperature read via the socket thermistor ?
--> Temperatures read at the diode can and will be higher than an external reading.

- Is the temperature sensor properly calibrated ?
--> Several board have this problem, check manufacturers bios revision history for calibration fix.

- Outside temperature high ?
--> If the external temperature is high, then the case fans will be drawing in hot air, especially during summer months.


Later

MD
 
You must log in or register to reply here.
Back
Top