New Motherboard & RAM

solarmute

n00b
Joined
Mar 12, 2004
Messages
3
I just ordered the Gigabyte GA-8KNXP (mainly because it has 6 DIMM slots) along with four sticks of Geil PC3200 RAM. My question is this... I have two sticks of Corsair PC2700 RAM at home. By using this configuration 2 x PC3200, 2 x PC3200, 2 x PC2700, will the motherboard downclock all of the channels to 2700 aka 333Mhz instead of operating in 400, 400, 333 respectively? Will this even work in dual channel mode? I'd appreciate any advice on this.

If anyone is wondering why I need 3GB of RAM, it is because I am planning to setup a 2GB RAM drive for 3D rendering work.
 
That's an odd question and an even more odd reason.

The motherboard will likely run the ram all at 333, or it may have options in the BIOS to change that.

As far as ramdrives go... why? Most render time is spent actually rendering. Readtimes are measured in milliseconds-seconds and rendertimes are measured in seconds-minutes.
 
The work I am doing is not batch rendering. It is a simulation application with very large textures and models which are streamed from the RAM drive.

So, assuming it runs all the RAM at 333 MHz (which is plenty fast), will is still be dual channel?
 
The RAM will absolutely be dual channel assuming you pair it properly.
I don't know how Gigabyte does it, so just make sure you go with the color coding on the slots and what it says in the manual.
 
yea, u have to read the gigabyte manual and see where you're suppose to put the ram.

if u cant find it, try putting the same amount of ram in each bank (i.e. 1gig in bank1, 1gig in bank2, and 1 gig in bank3)
 
Back
Top