New Hardware = Oddness Unless CMOS Reset. Why?

Deeky

Gawd
Joined
Feb 7, 2008
Messages
982
I've made two changes to my hardware config in the last two days (new PSU and new sound card), and both times it's caused me some minor grief. If I don't reset the CMOS, the system seems to "struggle" to power up from a cold boot. It powers up for a second or two, powers down, and then finally powers up successfully. Is there a reason for this? Is there a BIOS setting I'm missing (Gigabyte GA-P35-DS3R)? I haven't changed anything at the BIOS level, so having this suddenly start occurring is odd.

The PSU swap came first. I initially attributed the odd powering up to a faulty PSU, but it seems to run fine once the system gets going, and yanking the battery and resetting the CMOS cured the problem. But now I've installed a new soundcard and it's happening again! It resets fine and comes out of sleep without issue, but powering up from a cold boot causes a hiccup in the process. I've had the mobo for years and have never had this issue until recently. I gotta think it's something to do with the new PSU (Corsair HX850w). Can anyone think of a reason for it?

Cheers!
 
Last edited:
The power up/down cycle happens with Gigabyte boards when the FSB or the RAM multiplier was adjusted in the BIOS or the OC isn't stable and the mobo does some sort of recovery, defaulting to stock speed.

Please check in the BIOS (Ctrl+F1) if the settings are correct for your setup (CPU multiplier, FSB, RAM multi and adequate Vddr).
For more info you can read t[H]is thread, specific for Gigabyte motherboards or ask BillParrish. ;)
 
It is adviced to always clear CMOS settings after even minor hardware updates (or BIOS updates). CMOS stores your hardware configuration and if something changes, the changes may not be detected unless the settings are cleared and reapplied.
 
Thanks, y'all. Of course, I've seen the behavior before, but only when I expect it (FSB/RAM changes, etc, like you mentioned Seb1). To see it now when there's no obvious reason for it is a little disconcerting. I'll give the thread you linked a once over. I'll likely end up clearing the CMOS again, as that seems to solve the problem. It's just weird that this board has seen at least a dozen minor and major hardware changes in it's time, and I've never before seen it struggle to power up from cold boot beyond the first reboot following the initial installation of new hardware.

UPDATE: Huh. I decided to take the path of least resistance before getting under the desk to reset the CMOS; I just loaded "Optimized Defaults" in BIOS, altered a few basic settings (AHCI, boot order, etc) and bam ... the problem appears to be solved. I'm gonna shut her down and and power off the PSU for a few minutes, see if it sticks.
 
Last edited:
Back
Top