motherboard testing

courtney01

Gawd
Joined
Nov 25, 2008
Messages
619
i read that a safe surface to test a motherboard on is the cardboard box it came in while placing an anti-static bag in between the board and the box.

1. Is the antistatic bag the bag that the motherboard was originally wrapped in? the dark grayish colored transparent bag?

2. The cardboard box it came in is glossy on the outside with their design, and doesn't feel like "naked" cardboard. Is that surface still ok?
 
i read that a safe surface to test a motherboard on is the cardboard box it came in while placing an anti-static bag in between the board and the box.

1. Is the antistatic bag the bag that the motherboard was originally wrapped in? the dark grayish colored transparent bag?

2. The cardboard box it came in is glossy on the outside with their design, and doesn't feel like "naked" cardboard. Is that surface still ok?

1. Yes
2. Yes
 
1. I was placing the CPU into its socket, and because my fingers were in the way, I couldn't place the CPU softly all the way until it was in place. Instead, about 5mm above the socket, I had to let it fall in and gently tap it a bit so that it was aligned properly. Is that going to damage the socket or the CPU?

1a. By the way, it's ok to touch the backside (silver part) of the CPU with my bare finger right?

2. I'm trying to put the lever back into place for the CPU load plate, but there's quite a strong resistance against the plate when I'm pushing it back down. Is that normal or is it supposed to be resistance-less? I didn't want to force it just in case it's supposed to be easy to push it back. I have checked that all the covers are off from the CPU and the load plate, and that the CPU is aligned correctly in the socket.

edit: Regarding #2, I inspected the load plate, and I noticed that when I let the plate rest atop the CPU without closing the lever yet, the half closer to the metal bar that holds the plate in place curves slightly upwards. (or to explain it differently, when looking at the CPU socket with the plate's hinge on your left so that you're lifting the plate to the left, divide the load plate in half with a line parallel to that hinge. Then I'm talking about the the right side half of the plate that has the lift tab that's supposed to be held down by the protruding bar connected to the lever. This half looks a bit concave when the plate's lying flat.) Because of this, the plate doesn't sit flat atop the CPU, but is rather raised a bit on that half, which is why the lever encounters some resistance. I don't know if this is normal or not. I raised the plate perpendicular to the board and looked at it from the side, and it is indeed very slightly curved.

edit2: Regarding #2 again, I finally found something online regarding a similar problem:
http://forums.hexus.net/help-technical-advisory/85375-installing-e6600-cpu.html
There's a photo midway that shows what my problem looks like. The people in this thread seem to say it's normal and fine, but I wanted to check with you guys.
 
Sorry to be buggy, but this uncertainty is stressing me out and I really need to test this mobo asap because I need to send off the rebate that's due very soon. Thanks.
 
Ther is always a fair amount of resistance so that the pins or land grid make good contact. if the processor is seated in the socket properly there should be no problem. Don't stress out about it.
 
Back
Top