How does socket 478 lock the CPU in place?

Hurting

n00b
Joined
Jul 27, 2004
Messages
7
When you move the lever down, does it just move the CPU pins into position and hold the CPU in place by just "grabbing" it?

The reason I ask is because I was removing the heatsink/fan from my new P4 CPU off of my new Asus PC4800E-Deluxe mobo and managed to yank the CPU out at the same time, with the socket locking lever still in the down position! I guess the thermal bonding between the heatsink and CPU was strong enough to pull the CPU out even with the CPU locked in place.

So I'm also wondering if I might have damaged the CPU or mobo in some way. After carefully slicing the CPU away from the heatsink, I put the CPU back in the socket but when I moved the lever back down, it kind of resisted with a grating sound. The PC then wouldn't boot or even go into POST. I tried this a couple of times before taking the CPU back out and reseating it. This time I noticed that the CPU didn't quite sit all the way in the socket so I gave it a slight push and it fell the rest of the way in. Then the socket arm locked in smoothly and after a getting past the mobo being confused about seeing a new CPU and what it thought was a failed overclocking attempt, the PC has been booting and running fine since last night. Also, I checked the CPU each time to make sure none of the pins were bent.

So, did I get lucky or do I have a time bomb on my hand? And is it more likely that the CPU or mobo got damaged when CPU came out? And am I the only joker that managed to do something like this? :(

Thanks,
Stephen
 
I've done this numerous times on my 2.4b / is7 - it doesn't seem to be a problem. You should be a little more careful though, you don't want to be securing a heatsink down on a CPU that isn't seated properly; that's just asking for trouble.
 
That also happened to me, but it also broke off a corner pin that was only jumper, but still that was pretty scary. Word of advice, take your time and be very careful cause you don't want that happening.
 
in my case its unavoidable, so I just try not to switch heatsinks too often
 
Thanks all. From what I'm hearing it sounds like I'll be OK and the machine has been running for more than a day now with no problems. I guess in the future, I'll make sure the CPU is hot so the thermal bonding will be soft before I try taking the heatsink out. Hopefully then it'll come out without yanking the CPU out with it.

Thanks,
Stephen
 
Back
Top