torrey.smith
I Love the Cock - Please PM Me
- Joined
- Mar 19, 2007
- Messages
- 738
My computer will turn on, but not even get to the first visual display and will just hang there. THEN, if I hold the power button till it switches off it will turn on and boot up when I try again.
It does this every cycle, so I'm hoping that it is traceable.
This happened after I put all 8GB of Kingston HyperX onto my Striker Extreme. I am currently running a 1:1 on the FSB and memory clock at 800 MHz. That is the only setting that has booted repeatably so far. (5-5-5-15 2.0V recommended by Kingston)
I'd like to get the FSB on my Q6600 back to 1066 MHz eventually, too. It's like being stuck in safe mode...
It does this every cycle, so I'm hoping that it is traceable.
This happened after I put all 8GB of Kingston HyperX onto my Striker Extreme. I am currently running a 1:1 on the FSB and memory clock at 800 MHz. That is the only setting that has booted repeatably so far. (5-5-5-15 2.0V recommended by Kingston)
I'd like to get the FSB on my Q6600 back to 1066 MHz eventually, too. It's like being stuck in safe mode...