Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Your bend is too tight. Increase the length of tube for that connection in order to soften the bend.
I use flexible tubing in my system. I just redid the whole thing maybe 6 months ago and i noticed today the tube that runs from my video card out to my pump has partially collapsed in on itself.
Why would this happen and how to I resolve it?
sorry,
when I did my upgrade I used new tubing. the routing is exactly the same as my previous route. where it collapsed there really is no bend. its not straight but its maybe like a 20ish degree bend.
Forget the tube type, same stuff i used previously.
Sounds like im draining this thing to replace that piece.
Guess ill wrap it in the coil stuff i have for the tighter bends. It is the last tube from any compnents that generate heat. It goes into the pump and then to the rad.
Maybe the video card creates a flow bottleneck a bit and the pump just sequeeze it trying to get fluid out?
I am no fluid expert. Also just running distilled.
It sounds like you may be onto something important with the pump pulling a slight vacuum due to flow restrictions in the video card. That would make as much sense as anything I typed. (if not more sense)
Do you eat hot dogs with chilli?Do you own a camera?
Do you own a camera?
Yes I know you are asking to take a pic and post it so we can all see...your question was just so out of left field
Forget the tube type, same stuff i used previously.
Sounds like im draining this thing to replace that piece.
Guess ill wrap it in the coil stuff i have for the tighter bends. It is the last tube from any compnents that generate heat. It goes into the pump and then to the rad.
Maybe the video card creates a flow bottleneck a bit and the pump just sequeeze it trying to get fluid out?
I am no fluid expert. Also just running distilled.
Your bend is too tight. Increase the length of tube for that connection in order to soften the bend.
Yes I know you are asking to take a pic and post it so we can all see...your question was just so out of left field