Catalyst 6.4 Driver released

[psupef2k]

It would not hurt to check for updated Bios and install if need be, good to hear it has gotten better. I to am still getting screen flickers when I open the advanced properties of the display settings. So i may try the 6.4 stand alone drivers & WDM Drivers to see how that works and maybe even the Omega Drivers to see which is better.

I have the most updated BIOS for this board as it is right now.

As for the Omega drivers, I looked and they didn't have drivers for x1900 series cards. Maybe I overlooked them?

 

[TheArchangel]

I did not get a chance to go look at the ogema drivers yet, I was going to go that route as a last resort, thanks for the heads up. I will go check on them in a few, just got home from work.

I have the most updated BIOS for this board as it is right now.
As for the Omega drivers, I looked and they didn't have drivers for x1900 series cards. Maybe I overlooked them?

 

[psupef2k]

Have any updated drivers been released recently? My struggles continue.

This morning I tried starting up my pc, had to reset 3 times to get it to boot past post, and when I did get it to startup, the video card driver is now not installed. It shows up in add/remove programs, but not in device manager and was detected as new hardware. I will have to reinstall them tonight when I get home, so I need to get the best drivers possible.

I also noticed that when I boot up, the post screen shows that the memory clock = unknown. Is this normal?

 

[Casej18]

Hey this is a noob question but what does it mean when some ones 6.3 cat which is the driver and "chuck" /w oblivion?