Calling Electrical Engineering Majors

ppandemic

Gawd
Joined
Feb 6, 2005
Messages
753
Ok so I have a laptop motherboard that I am trying to rig up to work since I do not have a charger.

What I am doing:

AC to 24VDC (via standard PC PSU, -12 as ground, +12 as Vcc)
note: +12VDC line is 15AMP and -12VDC line is 0.8AMP

Running the 24VDC through a parallel circuit consisting of two resistors that results in 19.4VDC
note: the laptop needs 19.5VDC to charge/run, but I am pretty sure 0.1V will not matter

Then I slide a 12g copper wire in the center of the laptop DC jack, and a 12g copper wire around the ring of the jack, and hook up the output of the resistor circuit accordingly.

the jack looks like this:

dell%20d600%20dc%20jack.jpg




My problem:

Before I put any type of load on the circuit, my multimeter reads 19.4V

Once I attach the laptop to the circuit, my multimeter reads 17.6V

AND

the laptop has no power (ON button does not work, nor the battery charging light turns on.)



any thoughts [H]?
 
You'll have to take the laptop appart and take you multi-meter to it. And change out the charging jack with something you can find the male connector for, if it's getting power that is. It should be doing something with that much voltage, all though I don't think the original power supply would have put out that much amperage, do you?
 
Why not use a standard laptop AC-DC adapter? Few PSUs appreciate not having the +5/3.3V rails loaded, and using a negative rail as ground is general bad practice.

You could rig up your own AC-DC 24V stabilized PSU, but by that time it'd probably be cheaper and easier to just buy an adapter.
 
You'll have to take the laptop appart and take you multi-meter to it. And change out the charging jack with something you can find the male connector for, if it's getting power that is. It should be doing something with that much voltage, all though I don't think the original power supply would have put out that much amperage, do you?

the PSU would have handled the amperage just fine (assuming my math is correct), however as the quote below states, it is bad practice to use the -12V (0.8A) as ground ... though it would have worked ... for a little bit ;)

Why not use a standard laptop AC-DC adapter? Few PSUs appreciate not having the +5/3.3V rails loaded, and using a negative rail as ground is general bad practice.

You could rig up your own AC-DC 24V stabilized PSU, but by that time it'd probably be cheaper and easier to just buy an adapter.

I have done some research on dell AC-DC adapters, appearently the center pin is used for a very simple data connection between the adapter and the laptop motherboard to determine the adapter's wattage and some other info.

...so my adapter was working correctly, but now I just have to crack the adapter's protocol. so I guess either way I am going to have to buy one of these. haha :D

makes for a good project though.

Thanks for your input!
 
Back
Top