Abit IC7 problem. burnt CPU? bad mobo?

defenseman

[H]ard|Gawd
Joined
Nov 20, 2000
Messages
1,738
ok, so my bro just put together some new parts...a 2.4C and an Abit IC7. he had a shit video card (apparently) so he had to put in a old piece o' AGP one. nonetheless, he was in windows with shitty visuals (lines all cracked out from the crap vid card) and he noticed his CPU was a bit hot (~51ish...not sure).

he heads over to the shit-shack to pick up some thermal paste (sigh...) and he boots ups, and boom, he sees and smells smoke (pretty damn stinky he says). he shuts her off, trys her again, and barely gets her to post before you shut off and wont turn on again.

he calls me, and i take him through some crap and sure enough, is P4 (4-pin) connector wasnt even connected. and his northbridge fan was lose on one side. the CPU seemed to connected correctly and no caps seemed to be blownn.


any idea what he could have fried? all that happens now is the mobo light goes on, and nothing happens with the power button is pressed. RMA?
 
The lack of the 12 volt cable couold caused a shortage which blew out the system. check the cpu. If your brother is fairly noobish he may have put on to much thermal paste and it might have dribbled over the pins when he mounted the heatsink and compressed the goo. I have booted a system once without the 12v connected but it didn't blow. and in fact I ran a celeron 2.6 for like a month without plugging it in. didn't blow though :rolleyes:
 
Back
Top