• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Best Stand For 27 Inch Monitors

S

Spunkyasp

n00b
Joined
Feb 3, 2011
Messages
10
Hello,

I'm sorry if this question has been asked before, however I need to make sure. I'm purchasing three of these monitors;

http://www.newegg.com/Product/Product.aspx?Item=N82E16824236103

I'm interested in an Ergotron stand, particularly this one with telescoping wings to add 3 more inches to each side;

http://www.ergobuyer.com/index.cfm?fuseaction=product.display&Product_ID=227


However I am wondering if this stand will be able to support these three monitors. That is because I'm not sure whether it calculates width or diagonally. This monitor is supposed to be around 25.5 inches in width.


Let me know if it will fit, thanks!
 
I may not have it fully tightened on the bracket, but I get a little bounce on the side monitors. I have two 24 U2410's and they are roughly 45 degree angle. This requires you to extend the arms out almost to their maximum.
im not sure about it even with the optinal tel branckets
 
I have done lots of research and have decided the beat route for me is to just use the factory stands and extend my desk a little more in the sides with carpentry.

I could be wrong but in the course of my research it seems that the LCD stand can be quite limiting in ability to locate them where you would like.

Excuse typos as this was typed on an iPhone.
 
Chief makes a nice triple monitor stand for ~ $300. Check my sig.
 
vjcsmoke said:
Chief makes a nice triple monitor stand for ~ $300. Check my sig.
Click to expand...

So you clamp that on a pole and basically have to make your own center stand for the system to attach to? How does the rotate and tilt and all that work for you? Can you get near 45 deg angles on the 2 outside LCDs?

Thanks!
 
Anyone think the King stand would work with three Dell u2711s?

The u2711s are 25.5 horizontal inches each, which puts it 1.5" more than spec would allow.

Anyone with the Chief KTA325B can say if they would work or if any easyish modification would work?

Save that, the next closest seems to be the AM4-2p mount over at ergomart? It fits 4 17" horizontal, or ~56"
 
Last edited:
You must log in or register to reply here.
Back
Top