Yes, true but the seller he's talking about had 7 complaints from different buyers. Several mentioned no response or intentional misleading info. I'm concerned that since the seller has stopped using that account he'll just resurface under a different name. That's why I'm intrested in knowing...
Once upon a time in a land far away there were ATI video cards being produced in a timely fashion. :D It's just a story. Still a story. Nothing happening last season, now or anytime soon.
The memory might be ok but I've had a bad expreience with the company. Bought 2x512 sticks of PQI 3200 Turbo. One stick is bad. Will not run in my system or other test systems. Company refuses to replace it. Actually says they did but didn't. Returned same stick. Now they are saying they...
Don't do it. I've got two sticks of PQI 3200 Turbo sitting in the closet. One stick is ok and the other is bad. I contacted them for an RMA number and they sent both the same sticks back to me saying they had replaced the bad stick. They did not. It was marked and is still marked in my...
DFI sli DR Motherboard
SD 4000+
PCP&C 550SLI PS
2x6800 GT Vid card
2X512GSkill or OCZ RAM
4x74 Raptors(4xRaid0)
NEC burner
Any floppy
Antec P160 Case
Zalman Heatsink and Fan Unless you're going water or phasechange
19"LCD Monitor 8/12/16 ms response time (399)
This comes in right at...
Tried the 1005.003 beta and had major problems. Board would not recongnize that SLI was enabled. Switch bios back to 1004 and no problem. Switch back to 1005.003= problem.. Seems as if each bios they put out has it's problems. I don't think they will get it together for this board. It...
Ive had the board for about a month. There are the problems with the bios that everyone has mentioned and there are problems that are not bios releated like the chipset fan. Some of the problems have been cured with the bios releases and some haven't. While I have my FX55 running at 3150 I...
On your board usually close to your battery, there will be your 3pin cmos with a jumper on it. With your power turned off you will move the jumper over to the other side. You can also remove the battery. It should take no more than 10 seconds to a couple of minutes. You then replace the...
If you are planning to use the WD format and parition utility on floppy after you configure raid, you will have to install one of the later bios. You should probably try 1003. I haven't had any problems with it finding the Raptors although I'm using the 74 gig Raptors in Raid 0.
Well no not really. I'm running at 230x13 at the moment but would like to crank the fsb up. I've had it at 14x230 but in order to drop the multi and carnk the fsb I need some voltage. The cpu is good to about 3.24 but that's working with limited voltage. Might be good to 3.3 if I had more...
What are the chances that Asus will ever come with some increased Vcore voltage. Is it possible to increase it with a Bios update? Have they ever done this in the past on their boards? Thanks.
Received my board last week. Had the ususal reboot problem with the 1002 bios. Changed to the 1003.005 and haven't had that problem. Using an Antec TrueControl 550 with 20 pin offset into 24. Using plain MSI 6800 cards in sli. Have a single 4pin molex to board in addition to the regular...
It is strictly due to using the 1002 bios. You can switch to the 1003.005 bios and that problem will go away. However they are Beta bios. I've been using the betas for about a week now and ocing fine. No reboot problems.
Using the 1002 I am able to oc but upon reboot I have to enter bios and back out to boot. I am still using the 1003.005 bios. Using the Manual setting I am able to go fsb all the way up to 300 with the help of the dividers and the multi settings. I'm reaching 250x12 with 400 1T 2.5 -4-3-7 ...
My board shipped with the 1002 bios. I was able to oc using those bios but still switched to the 1003.005 beta bios. I am also able to oc with these. Sounds like a setting in bios. Have you changed your HT setting to 3 instead of 5. I've also noticed this board is very responsive to ram...
A8N SLI/OCZ 4200/FX55/2x6800 MSI/Ultra 550watt PS/VapoLS
1.Motherboard will not reboot. Have to enter bios,save and exit on reboot. Problems fixed by switching to 1003.005 beta bios. I haven't done an install with this bios to see if there are any sata raid detection problems
2. Some locks...