So after frying my x58 board and getting a replacement.. i got a 930 and figured I'd just rebuild the 920 into a different box and maybe give it to my brother or something...
I got some shin-etsu to replace the paste on my h50.. the x23-7783D.. I tried applying it in a thin layer as per the [H] recommendation since its a thicker paste.. but .. I ended up going with a 75% of the size of a pea in the center because it was too thick to spread..
I'm curious if my temps are showing that I don't have the cooler seated the best or paste spread the best? They are different across all cores.. (but lower than my 920..) So I'm unsure.. I screwed down the bracket in an X pattern.. doing about 3-4 screw revolutions before moving to the next until it was tight down..
Temps below...
I got some shin-etsu to replace the paste on my h50.. the x23-7783D.. I tried applying it in a thin layer as per the [H] recommendation since its a thicker paste.. but .. I ended up going with a 75% of the size of a pea in the center because it was too thick to spread..
I'm curious if my temps are showing that I don't have the cooler seated the best or paste spread the best? They are different across all cores.. (but lower than my 920..) So I'm unsure.. I screwed down the bracket in an X pattern.. doing about 3-4 screw revolutions before moving to the next until it was tight down..
Temps below...