Hey all,
I thought everything was running smoothly with my setup:
C2D E6600
2Gb G.Skill HZ
P5B-Dlx
EAX1900CF
2x320GB Seagate .10
XClio 650W
Till yesturday when the gf was surfing around and the screen went black (didn't shut off) and now the system will not post. Tried pulling power for awhile, tried CMOS Jumper, pulling the battery, waiting, all combinations of the above, pulled all other components out, etc etc
It doesn't beep, no keyboard lights, nothing. Hitting Reset on case causes the board to cold boot (power down, then up after a second or two). Tried one stick of ram at a time, same result. Can get it to beep if pulling out both sticks of ram, other then that its silent.
Is there anything else I should try, maybe something with this board, or just something I might be forgetting before I contact Asus for RMA ???? Maybe this isn't a MB problem ? I'll try some different ram, but I am kinda thinking its the Mb.
Thanks, Also if anyone has a recommendation for an Intel ICH8R or higher board (not sure what the hot board is right now) I would consider switching to,
st
I thought everything was running smoothly with my setup:
C2D E6600
2Gb G.Skill HZ
P5B-Dlx
EAX1900CF
2x320GB Seagate .10
XClio 650W
Till yesturday when the gf was surfing around and the screen went black (didn't shut off) and now the system will not post. Tried pulling power for awhile, tried CMOS Jumper, pulling the battery, waiting, all combinations of the above, pulled all other components out, etc etc
It doesn't beep, no keyboard lights, nothing. Hitting Reset on case causes the board to cold boot (power down, then up after a second or two). Tried one stick of ram at a time, same result. Can get it to beep if pulling out both sticks of ram, other then that its silent.
Is there anything else I should try, maybe something with this board, or just something I might be forgetting before I contact Asus for RMA ???? Maybe this isn't a MB problem ? I'll try some different ram, but I am kinda thinking its the Mb.
Thanks, Also if anyone has a recommendation for an Intel ICH8R or higher board (not sure what the hot board is right now) I would consider switching to,
st