I just got my X1900XT, and last night, after laying HL2:EP1, I decided I should install my Audigy 2 ZS since the onboard audio wasn't cutting it. So I put that in, and everything ran fine for about a minute. Then EVERYTHING went discolored. I'm talking BIOS, startup, everywhere. All my computer parts are brand new and never been overclocked, though I'm trying to figure out how to OC my D975XBX (not the best board for that). Here's my specs:
Intel D975XBX
Pentium D 930 (cooled wih CNP9500)
Corsair Twin2x2048-6400
X1900XT
Audigy 2 ZS
I also noticed that when this happened, my PSU was extremely hot. Could there be a power routing problem with the ZS or X1900XT that caused ti to draw too much power? And do I need the molex cable in the motherboard?
Intel D975XBX
Pentium D 930 (cooled wih CNP9500)
Corsair Twin2x2048-6400
X1900XT
Audigy 2 ZS
I also noticed that when this happened, my PSU was extremely hot. Could there be a power routing problem with the ZS or X1900XT that caused ti to draw too much power? And do I need the molex cable in the motherboard?