Recent content by xxroxx

Hey Necere! Thanks for the reply. Those pictures got me aching for a while now. The thing is, with that config, I'm out of options for a 3.5" mount, right? That's the last thing I'm trying to figure here. Dual rads, ATX psu, fully WC'd system + ODD would be a dream. But maybe I'll have to...

Hey guys! I have some doubts I'd like to clear before purchasing a M1. 1) With a WC'd GPU, can I fit a 3.5 HDD on M1's floor? 2)Mounting a SSD to the back of the front panel will prevent me from mounting a slim ODD on the front? 3) With a WC'd GPU, can I fit a 120mm rad on M1's floor? The...

is there any non-modular atx psu that fit in with a full sized GPU and have a decent amount of power output?

Hello! Just passing by to tell you that this project isn't dead. I'm actually almost done with the design! For simplicity sakes, however, I had to make some compromises. The actual case measures around 10L. Fits 1 240 mm AIO or two 120. That way it also fits a Hard Drive, ODD, SDD, I TX mobo...

Very few mm :p But pressure should take the air out.

It's just to show possible mounting points :p

So, here's how everything goes in: Any comments/suggestions?

Still in CAD. I've been busy this days with work + girlfriend + school. But maybe in one, two months I'll have my prototype. Also, I'm studying using acrylic in some parts :p so that delayed the project a bit.

News! So, here's a proper render (altought quite failed, I know) and my current progress in SW. Maybe it'll get done before schedule - though I still got to get some specs for properly mounting hardware inside of it. It currently sits at 10.2L, fitting a 2x120 rad, integrated pump/block, up to...

How many are left? How much will them cost?

Finally, some news! So, my parts are all together now and I'm running them inside a CM Elite 130. Temps are OK, even tought it's ~31°C in my room right now. Here is the link to the gallery: http://imgur.com/a/LeIA0 Thanks! PS: I'll now proceed with finishing the case and drawing it in CAD.

So much inspiration... What a great project!

Hello! I've just finished building my provisional system and I cannot get to the BIOS. I believe it is a RAM problem, but I'm not sure. When I boot up the system, a red light turns on near the 24pin connector and the ram modules. My specs: 4770k; Asus IMPACT ITX mobo; Corsair Vengeance...

Could you dumbd this a little bit more? I'm not sure if I got it :p ############# PARTS ARE HEEEERE!

Oh, these really aren't renders. I know what renders are :D my bad Well, yeah. Reservoirless would be an option. T line? And, as dissapointing as it might sound, perhaps I'll go x2 AIO for this. Still studying it, tho.