I wasn't able to solder it on, but it's being held in place with epoxy now. It's apparent;y doing very well, and the chip doesn't seem to be damaged at all while using the computer. @_@
Hmm. Didn't know that.
Okay, I think I'll bend the legs a bit, solder it, and add epoxy. Hopefully it's overkill that'll hold. =D
I'll post results here tomorrow or so when epoxy cures. =)
The method I described above was used with another heatsink with the exact same kind of retention mechanism as the one you're dealing with. But if you don't think it'll work, then that's your choice.
Oh. Okay then. But that still doesn't really help me as the legs are way too short to bend...
The legs are very short, thus will not bend very far. Not only that, but the anchor is used to hold a spring in place, which holds the heatsink in place. It's under a lot of presure due to the spring thing, thus I dounm't think the method of bending legs outward would work in this particular...
Hello,
My girlfriend has been complaining that her computer is running a little slow when she plays games. Please note that her computer is fairly slow to begin with; it's pretty old. But it just recently started to freeze and run super-slow. So I figured I'd clean it out, thinking that dust...
I'm pretty sure I will be able to get it to work. I'm probably not even going to go with Ubuntu. I'll most likely go with Arch Linux, or another lightweight distro. Like I said, I haven't even begun to really look for one. But thanks for the warning. =)
Thanks for your concern, but I think I...
Hello, long time reader, first time poster. :)
I've been thinking of doing a project like this for a long while now, and hopefully I can start on it soon. Let me start off by saying that I'm looking to build an extremely budget-friendly HTPC. The motherboard that I'm looking at is the famous...