Thanks for the tips.
Another thing i am wondering is that.
I have the 3 disk assigned as C,D and F drive. And i have 2 gig paging file on C and F drive.
So, if i use program that resides on F drive. Will it use F drives paging file or system disks one?
I have all my disk on sata ports on mobo, so they use same controller i think.
So basically there would be no use to use disk specific paging file?
Gonna use system disk one instead i think.
Not sure if this is right forum to ask this question but here goes.
Been wondering about paging files.
I have 3 hard disks and only system one has paging file currently.
But what if i enable paging file on different disk, does that disk data use that disk paging file or does it use system...
You might get even more off, i have x2 5600 idle temps at 28 C' and never goes above 35 in use. When i used air cooling my temps would go as high as 58 C', thought that was with basic stock cooler that come with cpu.
Ahhh, ok that clears it up.
Thought that if you once take out the block to change something on system etc, you cant use it again. As it would be ruined to be used again or something :)
Ahh.
What i meant was that i am thinking of adding GPU block on the loop and now wondering how to drain all of the liquid outta loop?
Knew about the "dont run pump without liquid" thingy.
Have kinda similar question. While getting rid of the coolant, can i start the pump only without powering up cpu to avoid damaging it when theres no coolant running just by plugging the mobo power connector out?
Lol, that was big sentence. :P
I think thats way too extensive maintenance. There is no wat that 1 month watercooling will need maintenance if built correctly. Though, who am i to tell anyone where to put their money on.