Recent content by timothius

I recently upgraded to the F7 bios and now the board refuses to boot if the RAM voltage is set to 2.2V. Anything below 2.2V is fine though. Anyone else having this issue? Anyone using 2.2V with the F7 bios?

Hi, Have a matched pair of Corsair 2gb DDR2 800MHz PC2-6400 XMS2 in the original box which was used for 3 days. I'm based in the UK and can provide my ebay feedback. I'm looking for around £55. Thanks, Tim

Crossfire works with the GA-G33M-DS2R motherboard as well.

If you click the download link the filename is f4d. Its misnamed I think.

Have they removed the 1:1 divider in the f4d bios? - I can't find it anywhere.

This board will work fine with a 20 pin atx power, but you must provide power to the cpu via the 4 pin plug near the ports.

I'm afraid the NSK1300 does not use an external PSU, unless its modified: http://www.hardforum.com/showthread.php?t=1210754

Its a 12V 220W psu, so all the current (18.3A) is on the 12V line. As most modern comps draw most power form the 12V line, its fine. A small DC-DC converter takes care of the other voltages, but there is hardly a draw from that.

I run pretty much the same with a 220W psu :P

Bump

Hi, I'm looking for some DDR2 800Mhz ram, 2gb (PC2-6400). I'm located in the UK. Thanks, Tim

I can't seem to get my board running over 400fsb either, but some people are managing it - although I wonder if thats in windows, or set in the bios. I just don't understand this issue.

Are you using integrated graphics?

You can undervold the N.B in the gigabyte...

Lambda are a very good PSU manufacturer - I would be surprised if it didn't pass all the tests.