Recent content by Teerex20

Bump

Very nice.

Oops just remembered I took off back plate and ran rods directing in res mounting points. Then used long rod connectors over ends of rod at Mount points to support. Can't think of name but they can connect 2 rods together.

When I initially had same setup,before I changed it,I drilled a few holes in mounting bracket and bought some threaded rods. I attached the rods to bracket and bent them 90° to run down to base of case to support the weight. I then changed it to 4 rods coming straight out of bracket going to...

I used these https://www.performance-pcs.com/pump-accessories/alphacool-decoupling-kit-eheim-hydor-4-decouplers.html and they were very good,just dont overtighten like you did on yours. Looks like you defeated the purpose. You have them overtightened and so compressed they become hard and...

Any cheap mics laying around? -- Bump

Pm + upsy....

Ill take the scarlett,send the bill.

Pm

Solo,1st or 2nd gen?

Might be easier as someone said to make it yourself,wouldn't be to difficult. Vidcard has watercooling now. I left computers for a while so it sat. Good thing cause when i came back vidcard prices were as we know out of control.

http://www.performance-pcs.com/phobya-radiator-stand-black-quad-4x120mm.html In stock,i should've sent you there first.

Newegg has it. https://m.newegg.com/products/9SIA9F96XX6723?ignorebbr=true&nm_mc=KNC-GoogleMKP-Mobile&cm_mmc=KNC-GoogleMKP-Mobile-_-pla-_-Case+Fans-_-9SIA9F96XX6723&gclid=Cj0KCQjwnNvaBRCmARIsAOfZq-2VUCqk-eFzRx3a6wHAsc5yGNdLd91Rp_paTDg6coJTXDg2FQ3-QTMaApZqEALw_wcB&gclsrc=aw.ds

Hey long time,290x still alive. Aquatuning has the bracket. https://www.aquatuning.us/water-cooling/radiators/mounting/7281/phobya-radiator-stand-black-quad-4x120mm

Ok,well there are some on ebay that might be modder friendly. Most have a round bottom plate but are for everything but yours. I'll keep a look.