Sugo SG01B-W, NT06-E, DFI Lanparty Jr P45, Intel Q9550.
Overall, its not to bad, very cramped in the CPU area though. Just got the quad and it runs HOT. At stock speeds and voltage, its around 65C full load, which to me seems pretty warm as it is only spec'd to go to 71C. Northbridge gets...
If you don't mind just a smidge of modding, What I did was I cut about 3/4" off the bottom of that drive cage so that I could plug the SATA cable in and kinda slide it into place. I also had to drill a couple of new holes and now the hard drives are alot closer to each other. Finally I cut...
Bah, yeah I just completely left out load temps sry. 54C after about 30min of Prime95 at stock speeds.
And yeah, I was talking about your 120mm in your Lanbox, I thought that was an NT06 for some reason.
I have the SG01B-W with the windows. It has the drive cage off to the side and not...
But the 4870 has much faster memory which will enhance performance when you don't need the extra memory. And from most of the benchmarks I have seen, the extra memory made little to no difference until you are resolutions at 1920x1200 or higher. I think that the 260 and the 4870 are pretty...
I just did this build last night, or at least mostly. Although I think I have a newer version of the SG01 that has the drive cage that is on the left side of the case. The damned DFI board has its SATA connectors stacked facing right into them. WTF. I ended up taking off the fan on the drive...