Recent content by sprout2287

bestbuy dropped a few cards today (a little over an hour ago), but i wasn't able to successfully get any to my cart. The "more details" button turned blue, "add to cart" turned yellow, and as soon as i'd click it, there was some red bar message about an "extra step needed" and try again. I was...

relooked at my "notifies" (login>my EVGA>my notifies) and i was mistaken (i thought i got in line in November). I actually got in line with EVGA on 12/17 for a 3060ti and 12/18 for the 3080. I am pretty far in the back of the line i'm sure.

At least it wasn't just me. Thanks for confirming. I will keep on refreshing I would even go up a notch or two (not nearing the $1000 mark though), but the higher end aren't all that enticing since i'll just be putting it under a full cover block anyway and clocking it a little higher. Ha, i...

Did I miss the bestbuy drop or did it not happen today? Been refreshing most of the day since 7am EST. I'm working on another computer, so I only refresh the site every few mins. My 1080ti is showing it's age on my ultrawide and this thread has given me upgrade fever. Also, anybody had a...

TBH, regardless of who to point the finger at, I had a 3600 in an opheon with a scythe big shuriken on it. Similar temps (40+ idles with mega-spikes 50+, and 90ish at load). Tried all the low volt/underclock, PBO off, and fan profile mods I could handle for a few weeks , and... Pretty much...

My version of a meta-analysis OP, I stole some of your data and added a bit of my own. Not sure how accurate this all is, but I used these cinebench scores as a baseline for this one. https://benchmarkwiki.com/wiki/cinebench-r20-scores-single-core-and-multi-core/ 'cause they posted all scores...

If you'd be able, I think adding an average cinebench score (or another agreed upon metric) then dividing the points scored by current market price would add a ton of value to the chart. Just my opinion though. Data doesn't lie if you have no agenda

https://www.3dmark.com/pcm10/44135552 Here's my 3600 for additional comparison https://www.3dmark.com/pcm10/44141085 and the 3900x

grabbed mine at best buy. It's white and I believe was for mac. Works well. I use it for the rear sensor with the extension. It's USB c to female usb 2.0. Can't report the functionality of the c to usb 3 though. I have a gl502 as well.

kryonaut here, or CLP between the IHS and core

Just cut the cord yesterday. Going the roku route. Actually was able to get plex/roku to do exactly what my HTPC was doing and turned the htpc into a little media server. Bonus for me. I already feel my brain cells regenerating, due to the lack of redundant crap content and commercials.

The gentle typhoons have since been separated from the scythe brand. Nidec servo still makes them. Look for the brand "darkside" and the gentle typhoon model. They tend to run about $20 a piece. Best IMHO, as well. Vardar are a very good copy and basically perform the exact same (RPM per...

good deal. I see a 2-3 c delta between my rads (2x120 and 3x120). One feeds the gpu block and the other the cpu. Pretty close to what you are getting. I'm running 56mm thick rads too fwiw. I like to use the rad output to judge the efficiency at the given fan speed (what I can control)...

The way you want to set it up is a temp sensor in the water and another of ambient air. Aquasuite lets you set up a "virtual sensor" that will reflect this delta temp. I have the inline aquacomputer ones, they look just like the phobyas. I have a sensor at the outlet of each of my rads. One...

GPU-Z says "not supported on this card"