Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
yeah i got 3.3v
Multi-Phase Controller It uses is ir35201
http://www.irf.com/product-info/datasheets/data/pb-ir35201.pdf
These are the voltages i got from it
Enable Pin 21 = 3.3
VCC Pin 38 = 3.3
dont know if i need anything else form it
12v is there just not the vcore after mosfets
resistance on two inductors under 8 pins is 1.4k and rising no short in diode mode
resistance on gate of high mosfet are all around 8.7k
resistance on gate of low side are all around 1.8k
never mind about the resistors my meter was giving different readings every time i measured just turned it off and on again seems to be ok now
measured them again they are all the around the same must be something else
think im nearing the problem Should the resistors R528,R29 and so on all be the same value?
R528 = 8.7k
R29 = 5.2k
R529 = 8.5k
R28 = 0.00
R530 = 8.7k
R652 = 8.5k
R38 = 8.7k
R78 = 8.7k
Its uses GS7256 for memory and memory controller
http://www.gstekic.com/pdf/GS7256.pdf
These are the voltages i got from memory controller (one on front of board)
Pin 1 = 10.32
Pin 2 = 1.33
Pin 3 = 0.34
Pin 4 = 9.65
Pin 5 = 11.92
Pin 6 = 0.60
Pin 7 = 1.17
Pin 8 = 0.76
These are the voltages i...
its some kind of logical and gate anyone know exactly what it is? its got 6 pads on it
i haven't been able to find a replacement anyone know if i can use an alternative
trying to repair an rx580 there are no shorts on any of the rails and all resistances are normal all voltages are present except vcore
dont know where to start with this one anyone know where to begin