Recent content by slickdf

ahh made a fool of me sen! didnt even notice. more vtt core it is then. :(

yeah I know as soon as i started my project it went dead on here and xs. :)

not got camera till 2morrow will get it up then and also 5 hours into the stress test and looking good :D

Updated with overclock to 4.3. Tell me what you think of temps and voltages.

Thanks mate!

Thanks for comments! Updated with some of my overclocking results so far.

Ok well just finished my antec 900 today, my first pc where i have painted, dremeled, tidy'd, changed fan blades blah blah. Anyway I would like to know what you think. http://uk.youtube.com/watch?v=OPtNw-h7wv8 Video of the lightbus skip to end if you want a little video of insides...

allready got backplate cable holes drilled. just a case of getting right lighting.

I have been looking and it the lazers seem to create a nicer overall effect. the CCFL's seem to just bleach everything and not looked that great. yeah if if i was to get lasers and leds what would be the best way to go about it. to create a nice set of leds going all over the shop. also if...

i got 2 120mm AC ryan black aluminum (cnt spell) dust filters. took the fan mounts off. unscrewed the fans. put the fan filters infront. re-sitted the fan and screwed back in. only problem was the screw must have been 1mm off reaching the screw fixing so had to go get a few longer screws by all...

Ive got some of my stuff together now I'm just not 100% on the holes.I got this motherboard... Then after I have drilled, whats best place to start? Will I need many extensions for fans or what? Please help!

Ok well went with the paper idea. Went well, simply marked it out with the plastic as template then used a stanley to cut out.Then just got a black perm marker to turn the white edges from the cutting black. Ended up looking nice and thanks for responses...

aye but what paint cause im sure most paint would just not stick very well to this material.

yeah its the alluminium silver one. only shop i could find it at was silver and last one in stock so got lucky to get it i supose. the paper behind then screwed to be in between sounds best tbh/ just tryed cutting some paper with a stanley and didnt seem sharp enough to cut circles. any other...